About Zbena.1

Zbena.1 · 2021-08-31

Zbena.1 · 2021-08-08

Zbena.1 · 2021-08-07

../TouchGFX/target/generated/TouchGFXConfiguration.cpp:17:10: fatal error: texts/TypedTextDatabase.hpp: No such file or directory fatal error: touchgfx/hal/GPIO.hpp: No such file or directory make: *** [TouchGFX/target/generated/subdir.mk:28: TouchG...

Zbena.1 · 2021-08-31

I see! thank you for answering

Zbena.1 · 2021-08-31

Here's what happened, I was reading the output voltage of an analog sensor and in fact, I disconnected the data pin to verify whether the given voltage of the ADC matches the one measured by a multimeter and it was when I noticed that the ADC still g...

Zbena.1 · 2021-08-31

yes , I calibrated the ADC first, here's the full code /* USER CODE BEGIN Header */ /** ****************************************************************************** * @file : main.c * @brief : Main program body *********...

Zbena.1 · 2021-08-08

I put the box and the graph widget then i generate the code, i don't generate the code in an empty gui

Zbena.1 · 2021-08-08

Do you think i might've done errors in the configuration or i probably missed something? I only select the touchgfx generator from the additional pack and activate the graphic and the crc, i read somewhere that i hve to do it with rtos also

User statistics

User Activity

Hello, I'm using STM32L476 to acquire analog values using ADC, the problem is the ADC returns values of 0.4v even when there's literally no input! How to fix it? and how much would it affect the measurement of the data I'm trying to acquire?

If I were to build a TouchGFX Gui on a non-evaluation kit (STM32L476RG) and load it into an external TFT Screen; what are the basic configuration that I have to make in the ioc file other than selecting the touchgfx generator and enabling the CRC?

I am trying to build a GUI to display a chart for STM32's ADC converted values, ; the code works fine before without touchgfx, but when i configure Touchgfx I generated the code from the application , then build the project, i get errors as whown below:

Re: Hello, I'm using STM32L476 to acquire analog values using ADC, the problem is the ADC returns values of 0.4v even when there's literally no input! How to fix it? and how much would it affect the measurement of the data I'm trying to acquire?

Re: Hello, I'm using STM32L476 to acquire analog values using ADC, the problem is the ADC returns values of 0.4v even when there's literally no input! How to fix it? and how much would it affect the measurement of the data I'm trying to acquire?

Re: Hello, I'm using STM32L476 to acquire analog values using ADC, the problem is the ADC returns values of 0.4v even when there's literally no input! How to fix it? and how much would it affect the measurement of the data I'm trying to acquire?

Re: I am trying to build a GUI to display a chart for STM32's ADC converted values, ; the code works fine before without touchgfx, but when i configure Touchgfx I generated the code from the application , then build the project, i get errors as whown below:

Re: I am trying to build a GUI to display a chart for STM32's ADC converted values, ; the code works fine before without touchgfx, but when i configure Touchgfx I generated the code from the application , then build the project, i get errors as whown below: