About AGupt.8

AGupt.8 · 2021-08-09

i have read the article, https://wiki.st.com/stm32mpu/wiki/How_to_start_the_coprocessor_from_the_bootloader#Starting_the_coprocessor_firmwarewhere will i find this in my device tree#define CONFIG_EXTRA_ENV_SETTINGS \ "stdin=serial\0" \ "stdout=serial...

AGupt.8 · 2021-09-02

i used my Windows system to flash it, and it was successfully flashed. but after flashing when i restarted the board, it halted at uboot console. i have attached the screenshot of my console. please guide what to do next in order to run my CM4 firm...

AGupt.8 · 2021-08-26

Your suggestion worked. But when i tried to flash it using ubuntu system it was showing error while reconnecting and was not able to reconnect. so i used my Windows system to flash it, and it was successfully flashed. but after flashing when i restar...

AGupt.8 · 2021-08-20

i am using STM32CUBE programmer to flash the board, i have not used cube-ide to compile uboot image, i am using openstlinux sdk provided by ST.I have followed the above steps that u suggested and downloaded the v2.1 starter package and its correspond...

AGupt.8 · 2021-08-19

is there any video which shows step by step process to start the coprocessor from bootloader?

AGupt.8 · 2021-08-19

i am extremely sorry but i didn't understood this part " PD 0x06 ssbl Binary mmc0 0x00084400 bootloader/u-boot.stm32 then re-flash the board.The cubeIDE generated files only the dtb file, are not useful."

User statistics

User Activity

Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?

Re: Hi,i am a beginner in MPU development. I have created cortex-M4 firmware project using stm32cubeide , but how can i start my firmware at the time of bootup?