About MOtt

MOtt · 2019-12-06

I am using the STEVAL-IDP005V1 and the terminal emulator, Putty, to output sensor data to my PC. I would like to plot the FFT data using Excel like is mentioned in page 20 of the Quick Start Guide. I have tried using the Putty configuration manager t...

MOtt · 2019-10-09

The LEDs labeled Sensor 1, Sensor 2, Sensor 3, and Sensor 4 are all flashing on my board even though I have the STEVAL-IDP005V1 connected to an IO link port.Are the lights supposed to keep blinking when I connect a sensor or do the blinking lights me...

MOtt · 2019-12-16

Hi Hal,Thank you for this solution, I was able to use the STM32Cube IDE to modify the communications .c file of the condition monitoring SRV project and create a new .bin file that has comma separated values I could copy in paste into Excel using ...

MOtt · 2019-12-06

Where can I find information on programming it to output a comma after each data variable?

MOtt · 2019-10-09

After looking at the photo in the STEVAL-BFA001V1B manual, the RS485 to USB adapter I believe they used is the antaira UTS-1458B.

User statistics

User Activity

How do I export the serial monitor output as a usable Excel file to plot the data with Excel?

What do the Sensor LEDs on the STEVAL-IDP004V1 board indicate?

Re: How do I export the serial monitor output as a usable Excel file to plot the data with Excel?

Re: How do I export the serial monitor output as a usable Excel file to plot the data with Excel?

Re: STEVAL-IDP004V1 (master-board) either not communicating to PC through RS485 or not detecting a sensor out of the box