About WOh.1

WOh.1 · 2021-09-13

Hi,When I use only X-NUCLEO-54L5A1 (Expansion board with VL53L5CX), VL53L5 GUI is connecting to X-NUCLEO-VL53L5A1 well.However, when I plug-in VL53L5CX-SATEL board to the LEFT, RIGHT or both connectors, VL53L5 GUI can't be able to connect to X-NUCLEO...

WOh.1 · 2021-08-23

I purchased P-NUCLEO-53L5A1 including X-NUCLEO-53L5A1 and NUCLEO-F401RE.And I assembled them and connect to PC, and then I installed its driver and reboot windows 10.When connecting, the explorer open the mass storage drive (D: (F401RE)).However, VL5...

WOh.1 · 2021-09-16

Hi Julien,I tried as your comment, but VL53L5CX GUI couldn't connect to X-NUCLEO-VL53L5A1.I used the firmware 53L5A1_MultiSensorRanging.bin from en.X-CUBE-TOF1_v2.0.0\Projects\NUCLEO-F401RE\Examples\53L5A1\53L5A1_MultiSensorRanging\Binary in en.X-CU...

WOh.1 · 2021-08-23

Hi,Thanks for prompt response, however I got a result as the below. However, by using another NUCLEO-F401RE, "Flash FW" was OK.Yes, you were right. After flashing and clicking on "Refresh List", COM port was shown.And then "Connect" was OK and "Mini ...

User statistics

User Activity

How to use VL53L5CX-SATEL assembled with X-NUCLEO-53L5A1

VL53L5CX GUI shows no list of VL53L5CX.

Re: How to use VL53L5CX-SATEL assembled with X-NUCLEO-53L5A1

Re: VL53L5CX GUI shows no list of VL53L5CX.