Posted on November 28, 2013 at 07:09hi guys, i am working with the LIS331DLH accelerometer, i was able to read the product ID but when i am going to set the config register 1 i am not getting acknowledgement, what may be the cause? #lis331dlh
Posted on June 04, 2014 at 11:42Me too have the same problem gyro is working but accelerometer is not working, is there any way to check whether it is a hardware problem or software problem or soldering problem
Posted on December 24, 2013 at 05:49hi mikhail, i am also getting the same problem while reading data through SPI, every time i am getting 0xff only, what may be the cause, and what is the problem of bed shouldering as you mentioned? could you elabo...
Posted on December 19, 2013 at 08:26 thanks for your reply, check the attachment, i am using this application note, now i am going to work with the interrupts and with the HP filter, in this case i am still in confusion how to set the th...
Posted on December 03, 2013 at 07:54now, i am getting the output, i am able to set the control register properly, i am using Little endian format and i am recieving some data from the OUT registers, i am in a slight confusion how to interpret that d...