About CCarl

CCarl · 2024-08-23

Hello,I have some troubles with the STSPIN32F0A when the load on the motor increases,the STSPIN will reset. The reset cause is checked in firmware at startup, and the cause mentioned is RCC_FLAG_PINRST.Apart from a pull-up and a capacitor to ground, ...

CCarl · 2020-01-29

Hello,I am looking for a reference design for a PFC with an input range: 300V - 400V RMS.The output power should be 180W. Thanks.

CCarl · 2024-09-02

Hello GMA,There is no drop visible on the VDD signal.It is like the STSPIN32F0A is pulling his NRST line low for some reason.

CCarl · 2024-08-30

Hello GMA,I am using STEVAL-SPIN3202 board.I checked NRST signal with scope and without jumper2,I see the NRST level is going below 2.8V when the load on the motor increases.That is when the STSPIN32F0A is reset.

User statistics

User Activity

Reset issue STSPIN32F0A

Reference design L6562AT?

Re: Reset issue STSPIN32F0A

Re: Reset issue STSPIN32F0A