About GAitc

GAitc · 2022-12-03

I am running Kiel uVision under the free LO licence and I can program the board and read it back in ST-Link V2 so i know I have connections to the device, however whenever I try and connect to the device to debug I get an error "Cannot access target....

GAitc · 2022-12-09

Thanks for that Tesla Delorean, it looks like this one will need some deep debugging. Thanks for your replies.

GAitc · 2022-12-03

Yes, thanks for that Tesla DeLorean I wasn't expecting such a quick response. To be honest it was more a generalised issue type of question, I have used a lot of STM32s but never had an issue getting a device up and running until trying the L010K. I ...

User statistics

User Activity

I can't seem to debug my STM32L010K4 processor, I have been through the layout with a finetooth comb but can't see any hardware issues. The device also does not run unless I go into the STM32 ST;-Link V2 and select run from the MCU_Core menu,

Re: I can't seem to debug my STM32L010K4 processor, I have been through the layout with a finetooth comb but can't see any hardware issues. The device also does not run unless I go into the STM32 ST;-Link V2 and select run from the MCU_Core menu,

Re: I can't seem to debug my STM32L010K4 processor, I have been through the layout with a finetooth comb but can't see any hardware issues. The device also does not run unless I go into the STM32 ST;-Link V2 and select run from the MCU_Core menu,