About GSing.9

GSing.9 · 2023-05-05

MLC was working and suddenly stopped working , checked all the registers related to MLC and all the writes and read were happening properly.Even tested accelerometer data in the same state and it was also working fine.My device gets powered on using ...

GSing.9 · 2023-06-21

One observation I had was that I am using lsm6dsox_pedo_debounce_steps_set a lot in my code to change the debounce count at specific intervals. In the function lsm6dsox_pedo_debounce_steps_set , there is lsm6dsox_ln_pg_write_byte function too, which ...

GSing.9 · 2023-06-20

Hi @niccolò @Federica Bossi I have checked the MLC state when the module stops giving the desired output( MLC stuck at 0 state, decision tree not giving output), MLC is enabled but the MLC state checks are showing zeros (register read of 0x1A and 0x3...

GSing.9 · 2023-05-11

I have debugged on this case and conclude that the only sensor that`s consuming this high current is lsm6dsox.You haven`t observed this behavior before?

GSing.9 · 2023-05-10

ODR for the accel is 104Hz and gyro is OFF.From the datasheet what I read is MLC shouldn`t be taking more than 15uA with every decision tree, and I have only one decision tree used.This actually is causing a lot of issues. Is there some state of MLC ...

GSing.9 · 2023-05-09

And this is when the module ideally works

User statistics

User Activity

MLC embedded on LSM6DSOX gets stuck and only works on power on reset, with software reset it remained in same stuck case.

Re: MLC embedded on LSM6DSOX gets stuck and only works on power on reset, with software reset it rem

Re: MLC embedded on LSM6DSOX gets stuck and only works on power on reset, with software reset it rem

Re: MLC embedded on LSM6DSOX gets stuck and only works on power on reset, with software reset it remained in same stuck case.

Re: MLC embedded on LSM6DSOX gets stuck and only works on power on reset, with software reset it remained in same stuck case.

Re: MLC embedded on LSM6DSOX gets stuck and only works on power on reset, with software reset it remained in same stuck case.