About THerm.1

THerm.1 · 2023-04-20

After that, both files could be flashed. After a RESET we got the following error message:Error: No STM32 target found! If your product embeds Debug Authentication, please perform a discovery using Debug Authentication 18:06:27 : UR connection mode i...

THerm.1 · 2023-04-25

Hi,I've tried to get access after pulling BOOT0 to High - several times - but without any success.It seems that the power setup regarding the LDO was wrong - in the current state of the controller one can measure around 0V at the VCAP pins while the ...

THerm.1 · 2023-04-20

we are able to connect via ST-Link without problems until the files for CM4 and CM7 are downloaded.After a power cycle there is no further access possible.We only have an alternate communication access via CAN port, either at pins PB6/6 or pins PD0/1...

THerm.1 · 2023-04-20

we use the CubeProgrammer for download the files. The settings for ST-Link configuration are as this:SWD8000kHzMode normal Acc.port 0Res.mode SW resetspeed reliableshared disabledAfter a new power up the target didn't respond - so we try to set the R...

User statistics

User Activity

Hi, we've a new custom-made electronics with two micros STM32H755. The first try connecting a ST-Link V3 via SWD was successful. Before flashing the two target files for CM7 and CM4 my colleague carry out a 'Full chip erase'.

Re: Hi, we've a new custom-made electronics with two micros STM32H755. The first try connecting a ST-Link V3 via SWD was successful. Before flashing the two target files for CM7 and CM4 my colleague carry out a 'Full chip erase'.

Re: Hi, we've a new custom-made electronics with two micros STM32H755. The first try connecting a ST-Link V3 via SWD was successful. Before flashing the two target files for CM7 and CM4 my colleague carry out a 'Full chip erase'.

Re: Hi, we've a new custom-made electronics with two micros STM32H755. The first try connecting a ST-Link V3 via SWD was successful. Before flashing the two target files for CM7 and CM4 my colleague carry out a 'Full chip erase'.