Hello,I have configured the BLE Beacon V1.0 sensor with the Nano Beacon software, I can detect it with applications like nrf Connect or ST BLE Toolbox. I've programmed a stm32 card as a client, I can detect the devices, but I can't detect the beacon ...

Hello,I program a BLE, I can send and receive data with the ST BLE Toolbox application.I want to use another application that is not programmed by the ST community to communicate with my server, I can receive data from this application but I cannot s...

Hello,I am working on a BLE project and I have a prolem of advertising table.- when I try to fill the advertisement table and I want to add more information, I don't see all the advertisements on the application, and I see the arbitrary information,...

Hello,I am trying to initialize my blueNRG-2N but I am not getting the expected values after a hardware reset.I should get through datashet: [02,7F,00,00,00], [02,7F,00,06,00], and [04, FF, 03, 01, 00, 01].The picture below shows the values I get.Do ...

However, when I ran the code on my custom board, I am not getting any data from the BLE. I am stuck at line hci_reset().I initialized the SPI and BLE but when I ran the debegger, I did not reach the line before hci_reset(); when I set the interrupt t...