About CKors.1

CKors.1 · 2021-07-29

The motor I'm using does not have Hall Effect sensors or encoders. What I'm confused about is what could cause an over current error. I'd like to note that for the motor I'm using, I do not know the specific values of certain parameters, such as the ...

CKors.1 · 2021-08-18

We did try decreasing the Nominal Current value, but it didn't solve the issue. We are also pretty confident that our motor has 6 pole pairs. I was able to turn off over current protection entirely, and while that solved the overcurrent problem, I ra...

CKors.1 · 2021-08-15

Hello,I have the motor profiler, but I'm unsure how to add the board I'm using to it. I have the STEVAL-SPIN3202 Inverter board, which as I understand, is essentially both a power board and control board in one. On the Motor Profiler software, the ST...

CKors.1 · 2021-08-05

Hello,The motor I'm using is a drone motor made by betafpv. The link to them is here: https://betafpv.com/products/1805-brushless-motorsUnfortunately, there isn't any documentation available about the motor itself. With that being said, we are fairly...

User statistics

User Activity

The primary issue I'm facing is that I'm experiencing over current fault whenever I try to start the motor, and I'm not sure what is causing it.

Re: The primary issue I'm facing is that I'm experiencing over current fault whenever I try to start the motor, and I'm not sure what is causing it.

Re: The primary issue I'm facing is that I'm experiencing over current fault whenever I try to start the motor, and I'm not sure what is causing it.

Re: The primary issue I'm facing is that I'm experiencing over current fault whenever I try to start the motor, and I'm not sure what is causing it.