About JakBSIP

JakBSIP · 2021-09-29

Hi all,I have been working on a Nucleo 68 board to develop firmware for my project. I have been working in parallel on two projects - one was purely hardware control - read/write to/from various peripheral devices (UART with IT and I2C DMA and Extern...

JakBSIP · 2021-09-09

Hi there,In short I am trying to use the Nucleo-68 board to scan for Cadence Sensor devices with UUID 0x1816 which I've managed successfully. I get a list of all available devices and their addresses (double checked against a report generated through...

JakBSIP · 2021-09-30

Update 3 and final:I have successfully integrated the code. I had to silence the Init_Exti() function. What I would like to know what is the disadvantage of doing so? What can happen if I use this in the Release version? So far for the past 30mins my...

JakBSIP · 2021-09-30

Update:MX_APPE_Init() disables all interrupts (apart from IPCC and semaphores) through Init_Exti() - why would that be the case? If I comment the line out, my BLE App still runs and now the button interrupt is caught, but then shortly after the syste...

JakBSIP · 2021-09-30

@Scott L�hr Thank you, appreciate the high level approach to the problem. While the first two paragraphs do indeed show the full picture which might be overwhelming to some, I have included for that reason an amazingly simple example below with a s...

JakBSIP · 2021-09-09

I have noticed that aci_gap_create_connection() can take a garbage MAC address and still return BLE_STATUS_SUCCESS, so I suppose that flag simply indicates that all went well on the STM32 side and it is now trying to connect to some peripheral.I have...

User statistics

User Activity

Combining BLE Application with Existing Project

Direct Connection Issue after Scanning

Re: Combining BLE Application with Existing Project

Re: Combining BLE Application with Existing Project

Re: Combining BLE Application with Existing Project

Re: Direct Connection Issue after Scanning