About RSeny

RSeny · 2019-05-24

2019-05-24 10:01:31.578471543 | processPps()2019-05-24 10:01:31.711095091 | $PSTMPPSDATA,1,1,1,0,0,0,0.500000,0,713,248,0,0,0,0,0,36,3,11,18,4,0,1.301e-08,65473955.16,25999998.74*162019-05-24 10:01:31.739373411 | $PSTMUTC,100135.000,24052019,12427272...

RSeny · 2019-04-18

Hi!UM2399 User manual ST Teseo III binary image on page 276 says:"If a specific configuration is required (see RF front-end reference manual for details about registers) it can be achieved by setting in the proper way the configuration parameters in ...

RSeny · 2019-06-06

Thank you, Francesco! This is useful information for me.Can you also take a look at previous branch with attenuator tuning question (How to increase attenuation value in Teseo III RF front-end?)?Values you suggested:CDB-140 @ 0x0ACDB-141 @ 40if it h...

RSeny · 2019-05-31

Hi, Francesco! I'm not using Teseo-SDK. I'm using UART to communicate with the module and digital signal 1PPS.So I have incoming PPS number Nthen group of NMEA messages by UARTthen next PPS number N+1as you can see in log in my first message with tim...

RSeny · 2019-05-08

Hi, Francesco!It seems that this:>In your case you have to set:>CDB-140 @ 0x0A>CDB-141 @ 40>if it helps, you can also tests different vales for CDB-141 (140 is mandatory @ 0x0A)does not work. :(I tried more values for CDB-141:$PSTMFEDATA,ff,ff,3c,6f,...

RSeny · 2019-04-30

Hi, Francesco!Tried CDB-140 @ 0x0ACDB-141 @ 40Results are partially successful. Module still alive :) . Signal value still the same :( (with external 10dB attenuator). My understanding it should be less with additional attenuation with frontend regis...

RSeny · 2019-04-29

Hi, Francesco!Thank you for the reply! I suppose to check it soon.By the way I suspect that there is no range check for parameter number. And I think that with RF front end registers we have the same picture.With different SW versions you have variou...

User statistics

User Activity

Which PPS $PSTMPPSDATA and $PSTMUTC messages related with? With previous or with next?

How to increase attenuation value in Teseo III RF front-end?

Re: Which PPS $PSTMPPSDATA and $PSTMUTC messages related with? With previous or with next?

Re: Which PPS $PSTMPPSDATA and $PSTMUTC messages related with? With previous or with next?

Re: How to increase attenuation value in Teseo III RF front-end?

Re: How to increase attenuation value in Teseo III RF front-end?

Re: How to increase attenuation value in Teseo III RF front-end?