About Ferdster

Ferdster · 2019-04-16

I have a small project that coded and prototyped on a 32F0308DISCOVERY board (STM32F030R8T6). It works perfectly on the Discovery board.I now want to switch over to using a STM32F030F4P6 programmed by the ST-Link that's on the Discovery board (CN2 ju...

Ferdster · 2019-04-17

It was something simple...I needed to remove SB19 and SB22 from the Discovery board.

Ferdster · 2019-04-16

I believe this is taken care of by removing the CN2 jumpers on the Discovery board. I mean they advertise that the Discovery board can be used to flash external chips. I will need to double-check that SB19 and SB22 are not populated though.

Ferdster · 2019-04-16

I just added a 220nF decoupling cap right at the pins and I already had the Idd jumper removed. Still can't do a full erase. It will actually only connect when SWD is set to 4000kHz, anything slower it gives the error that the target is being held un...

User statistics

User Activity

Flashing STM32F030F4P6 from 32F0308DISCOVERY board

Re: Flashing STM32F030F4P6 from 32F0308DISCOVERY board

Re: Flashing STM32F030F4P6 from 32F0308DISCOVERY board

Re: Flashing STM32F030F4P6 from 32F0308DISCOVERY board