About Eakso.1

Eakso.1 · 2024-07-04

Hello everyone, I am Erdem.I am trying to use FlexCan with the SPC560B-DIS development board. I ran the example project "SPC560Bxx_RLA CAN Test Application for Discovery," but I didn't want it to operate in LoopBack mode. When I disabled the LoopBack...

Eakso.1 · 2024-02-05

Hello, I am Erdem.I am an R&D engineer at Devimsel Elektronik. I will use the SPC560P processor on my own PCB board. For this I need instructions for using SPC5 studio. How do I make configurations such as pin and clock tree? Can I get an instruction...

Eakso.1 · 2021-06-25

I have Nucleo-F302R8T6 and STEVAL-IPM15B. But I don't know how to connect the pins. I tried to connect it by looking at the pins from the Motor control workbench program, but some pins were exposed, RX, TX pins were exposed. Can you help me how to c...

Eakso.1 · 2024-07-05

It is done, thank you

Eakso.1 · 2024-07-05

Thank you for answer. I got it done :)

Eakso.1 · 2024-02-05

I want to use the SPC560P processor in the control card I designed. How will I code this processor with the HAL driver?

Eakso.1 · 2021-06-27

I have the same problem. But ı can't solved it.

User statistics

User Activity

SPC560B-DIS FlexCan can't communicate

SPC5 Studio

How I connect to Steval-IPM15B ?

Re: SPC560B-DIS FlexCan can't communicate

Re: SPC5 Studio

Re: SPC5 Studio

Re: Where do I can find the pins that I have to associate between NUCLEO-F303RE and STEVAL-IPM15B 3Sh if I want to use it for motor profiling ?