About TBlak

TBlak · 2022-10-01

Hi,I'm having trouble getting serial data out of my STM32 Nucleo board. I managed to get this working a few years ago but for some reason it's not working for me now.The board that I'm using is an NUCLEO-F413ZH and I'm using a USB-TTL serial cable (T...

TBlak · 2019-03-22

Hi there,I have an FTDI USB-Serial cable connected to a NUCLEO F413ZH. I am running the UART_Printf example from STM32CUBE_FW_F4_V1.18.0 in Keil but am not getting any output in my serial terminal (PuTTy).I have connected the USB-Serial cable to the ...

TBlak · 2022-10-07

See above

TBlak · 2022-10-07

Got the code working. I found this tutorial which was super helpful:Nucleo UART Tutorial | DMC, Inc. (dmcinfo.com)I'm pretty sure I was just hooked up to the wrong pins but it was beneficial to learn how to use CubeMX to make the setup easier.Thanks ...

TBlak · 2022-10-01

Fixed this code but still no joy:#define USARTx_RX_GPIO_CLK_ENABLE() __HAL_RCC_GPIOA_CLK_ENABLE()#define USARTx_TX_GPIO_CLK_ENABLE() __HAL_RCC_GPIOA_CLK_ENABLE()

TBlak · 2019-03-28

@Uwe Bonnes Yes I see now that the USART3 interface available on PD8 and PD9 of the STM32 can be connected either to ST-LINK or to ST morpho connector. I've edited the firmware to use USART2 instead and am now successfully getting output in my seri...

User statistics

User Activity

No data in Hyper terminal - STM32 Nucleo

How to use USB-Serial cable with NUCLEO

Re: No data in Hyper terminal - STM32 Nucleo

Re: No data in Hyper terminal - STM32 Nucleo

Re: No data in Hyper terminal - STM32 Nucleo

Re: How to use USB-Serial cable with NUCLEO