STM32CubeMX:5.2.1Target Toolchain: ST STM32CubeIDEFirmware Package: V1.10Drive Tye: HALMC Frmware Library: 5.4.0 After I format my computer, I reinstalled Motor Control Workbench.Code generation has a error "Can't add MW MotorControl"My OS use Korean...

I want to send 16bit spi. 8bit data is not enough because 10 bits are required.I think (uint16_t) data was the data bits which I want to change.I increased it 00 to FF but the result (SDO: Green) is quite different to what I intend. Please review my ...

I generated FOC code by 3 shunt from MCSDK5.3.3.the base project comes from STM32CubeExpansion_SPN7_V1.1.0. The MCU is STM32F302R7Tx.Please review below code and respond the error.static void MX_NVIC_Init(void){ /* TIM1_BRK_TIM15_IRQn interrupt confi...

arm-atollic-eabi-gcc -o NUCLEO_190413_3shunt_5000RPM.elf Drivers\STM32F3xx_HAL_Driver\Src\stm32f3xx_hal.o Drivers\STM32F3xx_HAL_Driver\Src\stm32f3xx_hal_adc.o Drivers\STM32F3xx_HAL_Driver\Src\stm32f3xx_hal_adc_ex.o Drivers\STM32F3xx_HAL_Driver\Src\st...

18:03:10 **** Rebuild of configuration Debug for project 190320_STM32_motor_test_1shunt ****Info: Internal Builder is used for buildarm-atollic-eabi-gcc -c -mthumb -mcpu=cortex-m4 -mfloat-abi=hard -mfpu=fpv4-sp-d16 -std=gnu11 -DARM_MATH_CM4 -D__weak=...