Dear Community,I have a setup of 2x SPIRIT transmitters. The CSMA is disabled. Both are configured for continuous TX. However, I observe the following:1) The SPIRIT that boots initially starts transmitting without any issues2) The second SPIRIT (that...

Dear ST Community,I have the following test setup:- 1x SPIRIT-1 transmitter (reads a pin from a STM32 MCU and modulates it over the radio)- 2x SPIRIT-1 receivers (receive the pin state and pass it to the MCU)Expectation: Both receivers should receive...

Dear ST Community,Aside from the SPIRIT1 DK, are there any short and simple examples for basic packet transmisstion and reception with SPIRIT1? The W-MBUS is desirable, but not mandatory for my use case. I have gone through the frequency and channel ...

Dear ST Community,After reading the SPIRIT1 datasheet and thinking over 2 days on it, I still have a lot of doubts and unclear points. May some help me with the following:1. XTAL and synthesizerI have put a 25MHz XTAL on my custom PCB. I saw in the d...

Hello ST Community,I have a PCB designed according to the attached schematic.Recently, I have been struggling with the following awkward issues:1) The flashed firmware (via UART) doest not always start (2/10 attempts lead to successful code execution...