About Magnet

Magnet · 2019-10-08

Hi,In the cases below I try to read value of an SRAM address which is in TIM2_IRQHandler(), from main() function or user Program() function, but no result!anyone who is experienced or has idea?void Program(); void TIM2_IRQHandler() { if(__HAL_TIM_...

Magnet · 2019-03-22

When I press Reset B2 button on the Nucleo ADC takes value, otherwise it waits! anyone helpp??

Magnet · 2019-10-11

Hi TDK,Case 2 does also comparison once, but no more! Additionally, value of "value" doesnt appear during debug in watch list.i wonder that, either reading and writing SRAM address simultaneously is possible or not?

Magnet · 2019-10-09

Tool chain MDK UVision KEIL V 5.26.2.0 - Mcu Stm32F767The program writes the values from 0 to 1000 to the memory address 0x20020000 , but doesnt read from memory!If only one of the cases below works (e.g. Case 3), that is enough.Whole Code is:#includ...

Magnet · 2019-10-09

Hi CliveTo.Zero,my purpose is not toggle actually, but read the address value. I've tried to use 'volatile' that you suggest and then i observed it on debugger, but no value is read on the lines 25, 32 and 42 again. if you have more info and share wo...

Magnet · 2019-03-22

Hi, I changed the config as you said and I triggered the input pin manually and/or changed potantiometer (because I dont have ability to use PWM yet). but It is not working.. any missing of Timer or another?

User statistics

User Activity

How can I read and write simultaneously on specific SRAM address STM32.

How can I get value using ADC interrupt continuously without DMA using stm32f7

Re: How can I read and write simultaneously on specific SRAM address STM32.

Re: How can I read and write simultaneously on specific SRAM address STM32.

Re: How can I read and write simultaneously on specific SRAM address STM32.

Re: How can I get value using ADC interrupt continuously without DMA using stm32f7