About GRand.1

GRand.1 · 2021-03-25

CubeIDE makes a completely different file structure, some includes cannot be found "VOID" is written capital and causes an error, etc. I am completely new to RTOS, I did some bare metal HAL with CubeIDE and that worked quite well, but just started re...

GRand.1 · 2021-04-15

Hello Haithem,I followed your screen cast (thank you for posting it) and run into the same problems as ADyke.1. The set-up was never an issue, although I started from a Nucleo template rather than from the uC like you, the problem started with the co...

GRand.1 · 2021-03-30

Hello Haithem,yes, I do use the latest (1.6.0). I tried a bare HAL project and it worked. I will next successively add one component after the other and see where it will lead me. But even in your (working) screen shot, the file structure is differen...

GRand.1 · 2021-03-29

Hello Haithem, no, I did enable all of them.Greetings, Guenter

GRand.1 · 2021-03-28

Hello Haithem, thanks for helping!I used STM32CubdeIDE, startet a new project and selected my board (H723ZG Nucleo). Then I selected my peripherals, timers, SPI, etc., in the .ioc, just as I did before on my F4 boards. However, this time I also selec...

User statistics

User Activity

Hello, I try to start with azure RTOS on a H723ZG and when looking at the examples (e.g. TCP-Client) it is completely different from code generated through CubeIDE from scratch. I hoped that generated code will be a working framework that I adjust/add.

Re: Hello, I try to start with azure RTOS on a H723ZG and when looking at the examples (e.g. TCP-Client) it is completely different from code generated through CubeIDE from scratch. I hoped that generated code will be a working framework that I adjust/add.

Re: Hello, I try to start with azure RTOS on a H723ZG and when looking at the examples (e.g. TCP-Client) it is completely different from code generated through CubeIDE from scratch. I hoped that generated code will be a working framework that I adjust/add.

Re: Hello, I try to start with azure RTOS on a H723ZG and when looking at the examples (e.g. TCP-Client) it is completely different from code generated through CubeIDE from scratch. I hoped that generated code will be a working framework that I adjust/add.

Re: Hello, I try to start with azure RTOS on a H723ZG and when looking at the examples (e.g. TCP-Client) it is completely different from code generated through CubeIDE from scratch. I hoped that generated code will be a working framework that I adjust/add.