About engtec

engtec · 2019-02-28

Hello All,I am using a NUCLEO-F401RE Board and a IKS01A2 Sensor Board with it. I want to collect the incoming data dynamically and modify it. By using Unicleo-GUI and just clicking Connect and Start I am able to observe the collected data. I want t...

engtec · 2018-12-27

Hello,I need to get position and track the motion of the IMU from the acceleration and other data it gives. I am using a Nucleo STM32F401RE board and a X-Nucleo- IKS01A2 MEMS sensor. I am using the DataLogFusion example in Unicleo-GUI. To get positio...

engtec · 2019-01-07

Ohh, Thank you for your insight.I was under the impression that after post-processing the data well with a few algorithms it would give a reasonably accurate estimate as this seemed to be a quite common application. I will implement null velocity, ig...

User statistics

User Activity

What commands should I send through the Serial COM port to a Nucleo-F401RE board via a Python Script and Command Prompt to replicate the Connect and Start options in Unicleo-GUI?

Error while Integrating Acceleration to get Position after Fusion

Re: Error while Integrating Acceleration to get Position after Fusion