About ASpar.1

ASpar.1 · 2021-05-03

ASpar.1 · 2021-04-15

or there is a way to set it by me?

ASpar.1 · 2021-04-13

ASpar.1 · 2021-03-29

the note says this: The STM32L microcontroller on the board is not intended to be programmed by users. ST provides a preprogrammed firmware image for the sole purpose of interfacing BlueNRG-1, BlueNRG-2 to a USB host device.

ASpar.1 · 2021-03-26

ASpar.1 · 2021-03-24

I saw that is possible using a SSD driver and specific functions to drive it by serial port. Could i load the txt file on an ssd and than the MCU could access to the txt by serial port. Is this a good solution?

ASpar.1 · 2021-03-24

i forgot that, i'm an idiot 

ASpar.1 · 2021-03-05

thank you. I had already seen this document. The problem is that the power to which these devices transmit is not indicated, therefore with the measured RSSI value, I cannot get an idea of how far and intensely these devices are able to transmit. I...

User statistics

User Activity

I' m using a board based on Bluenrg2. I want know how can i scan all the advertising packet sent by other devices and where their informations (address, rssi ...) are stored and how can i accest to them.

I'am using a blueNRG2 BLE MCU and i am realizing a beacon BLE. I know how to set data packet , advertising address etc but scanning by smartphone i noticed that there is a parameter Device UUID that is not setted by me.Is it specific for any ST BLEdevice?

I have an steval-idb8v2. I'd like to program it by custom firmware writed by me. Anyone can tall me what IDE and program i need to do that. I don't want use the DK. Thanks for the help.

I'm doing a project with a steval-idb008v2 and I have a doubt due to a small note. Can the steval-idb008v2 be reprogrammed with a code created specifically by the user?

I can't understend wich ones are the SPI pins for the board of steval-idb00xxx family. Can anyone help me?

Re: I have an algorithm in C wich read and write a .txt file. I know that i could do this by serial port but need of it on the board for a stande alone application so i want to know if i just drag the file i the .txt file into the mcu like for programing one

Re: I have an algorithm in C wich read and write a .txt file. I know that i could do this by serial port but need of it on the board for a stande alone application so i want to know if i just drag the file i the .txt file into the mcu like for programing one

Re: I'm trying to built a beacon net to localize a smartphone thanks the advertising sent by the beacon. I need of a small ble solution with a good coverade range. So i'd like to know if the STEVAL-BCN002V1B can be used in this way and how much is its range.