About fDNTI

fDNTI · 2018-12-05

After upload my program into a stm32F103C8T6, the program doesn't start. I just use STM32CUBE-MX to configure my mcu, and I just add some blinking on 5 output (push/pull). But after reset my output seems to stay in high inpedance ? Does Mcu start its...

fDNTI · 2018-12-05

My (other) problem is I reuse a board and debug pins are not welded ! I just added 4 pins to upload with st-link. I haven't quartz on board so I need to use internal clock, Is there something special to start it ?

fDNTI · 2018-12-05

There's a beginning to everything, but it's not help ! I already done basic steps, this is the reason why I ask help, to have a higher level of help !

fDNTI · 2018-12-05

Yes of course, Sorry I didn't mentioned it. I obviously Build project without error, before uploading. I hadn't choice I need .hex file or .bin :)

User statistics

User Activity

Why my STM32 doesn't start to run ?

Re: Why my STM32 doesn't start to run ?

Re: Why my STM32 doesn't start to run ?

Re: Why my STM32 doesn't start to run ?