About FDepr.1

FDepr.1 · 2021-02-23

Hello,I am using the LIS2DW12 accelerometer using Zephyr OS.Driver code is https://github.com/zephyrproject-rtos/zephyr/tree/master/drivers/sensor/lis2dw12 I configured the chip as follow: ODR is 12_5Hzlis2dw12_reset_set(ctx, PROPERTY_ENABLE); lis2dw...

FDepr.1 · 2021-03-03

I just checked, and it seems that the MCU had some pullup on the pins used for the irq. Now the consumption is fine Thanks for your support.

FDepr.1 · 2021-03-03

Hello Eleon,I now use lis2dw12_int_notification_set(ctx, LIS2DW12_INT_PULSED);To make sure the interrupt is not latched by setting LIR of CTRL3 to 0.It did not help the power consumption increase when we are in activity to inactivity state. I do not ...

FDepr.1 · 2021-03-03

Hello Eleon,I found part of the issue. It seems that there is a pin set to 1 when the device is inactive and which goes back to 0 when it is in activity.I updated the pin polarity using lis2dw12_pin_polarity_set(ctx, 1); which writes into the h_lac...

FDepr.1 · 2021-03-03

Hello Eleon,You can find the content of the register once everything is configured:ctrl1: 0x30ctrl2: 0xcctrl3: 0x0ctrl4: 0xe0ctrl5: 0x20035ac0ctrl6: 0x40ctrl7: 0x60int_dur: 0x0free_fall: 0x20029c00Let me know if you need other registers.Also, we upda...

FDepr.1 · 2021-02-25

Hello Eleon,We have 2 pullup resistors of 10kOhm, one on both lines of the I2C which are connected to the VCC_3V0.When we start, we do not have overconsumption, it seems that the accelerometer is in the ACTIVITY state and after the 41 seconds of INAC...

User statistics

User Activity

LIS2DW12 activity/inactivity power consumption too high when inactive

Re: LIS2DW12 activity/inactivity power consumption too high when inactive

Re: LIS2DW12 activity/inactivity power consumption too high when inactive

Re: LIS2DW12 activity/inactivity power consumption too high when inactive

Re: LIS2DW12 activity/inactivity power consumption too high when inactive

Re: LIS2DW12 activity/inactivity power consumption too high when inactive