About sara h.

sara h. · 2018-11-19

I am working with STEVAL-MKI109V3 and STEVAL-MKI180V1 (Lis3d). After finally getting the drivers and firmware etc. sorted so that the device is recognised by Unico, it seems now that Unico is not showing the complete set of tools: in particular I am...

sara h. · 2018-11-23

Hi Miroslav,thanks for your reply - I got the MKI105V1 now, and can set the interrupt registers in Unico. that was the easiest option, I think ;)

sara h. · 2018-11-20

Postscript: Say, if I used a STEVAL-MKI105V1 (https://www.st.com/content/st_com/en/products/evaluation-tools/product-evaluation-tools/mems-motion-sensor-eval-boards/steval-mki105v1.html) instead of the STEVAL-MKI180V1, which has the 'complete LIs3DH...

sara h. · 2018-11-20

Hi Miroslav, thanks for your quick reply.I am not sure I understand correctly: Unico does not support this at all? is there a different version of Unico that does support interrupts? Also, do I understand you correctly that even though the LIS3DHH h...

User statistics

User Activity

Unico: no interrupt tool

Re: Unico: no interrupt tool

Re: Unico: no interrupt tool

Re: Unico: no interrupt tool