About ToolV

ToolV · 2019-02-07

Hi,i've installed Unicleo-GUI to test X-NUCLEO-IKS01A2 MEMS but the GUI is not starting. In addition i have installed latest Qt5+MinGW64, AlgoBuilder and STM32CubeMX with Firmwares. I see the Unicleo-GUI.exe popup in Windows Process Explorer and afte...

ToolV · 2019-01-14

Hi Trilys,you mentioned that you have min. 7 Sensors " but the # 7 return error ". With 10 pF capacitance for each SDA IO Pin, L1 Datasheet, 4.1, Table 10, you will get 7*10 pF of parallel connected modules. Together with 5.9 kOhm Resistance it bui...

ToolV · 2019-01-08

Hi Ameer,"So i only have the basic options for the parameter setting which include time budget and measurement mode. " - Do you mean distance mode or is there some implemented functions in GY-53?As you have jitter by measuring an object above max. se...

ToolV · 2019-01-07

Hi Ameer,as i pointed in UM2356, 2.5.5, p. 12: " No targetThis is an alternate detection mode. In the standard use case, if no target is detected, noranging is reported. Using no target detection mode (setting IntrNoTarget to 1) allows aninterrupt to...

ToolV · 2019-01-07

Hi Trilys,you can validate your I2C Interface over 3 registers mentioned by L1 Datasheet, 4.2, p. 22. Which I2C Resistors are you using? Are there any other I2C devices on the same I2C bus?Regards

ToolV · 2019-01-07

Hi Ameer,i could imagine, that TOF Sensor operates in multi-pulse operation mode. In such mode the measurement signal is modulated sinusoidally. For the distance measurement, the phase shift between the transmitted and received modulated light pulses...

User statistics

User Activity

Unicleo-GUI not starting

Re: [VL53L1x] VL53L1_ERROR_CONTROL_INTERFACE when VL53L1_GetMeasurementDataReady() called

Re: Out of range readings of VL53L1X

Re: Out of range readings of VL53L1X

Re: [VL53L1x] VL53L1_ERROR_CONTROL_INTERFACE when VL53L1_GetMeasurementDataReady() called

Re: Out of range readings of VL53L1X