About JWoeb.1

JWoeb.1 · 2021-01-25

Hello,When configuring the LSM6DSL ( STEVAL-MKI178V1 ) to sample Data at 6664 HZ ( without any digital Filters active, FS= +- 16g, +- 250deg/s ) there seems to be an consistent 1deg/s @ 800Hz noise on some gyro axis. The same signal but stronger ( > ...

JWoeb.1 · 2022-11-24

@Eleon BORLINI Hi, is there any example on how to use the sensor-hub functionality of the ISM330DLC specifically? The examples for LSM6DSL don't seem to work. I guess it has something to do with the fact, that ISM330DLC has the additional operation M...

JWoeb.1 · 2022-11-23

@APatel.13 Hi, I am currently having the same problem that I replaced a LSM6DSL ( connected via SDx, SCx to a LIS3MDL compass ) with a ISM330DLC. But the sensorhub communication now does not work anymore. After starting a transfer by reenableing the ...

JWoeb.1 · 2021-01-27

Our main worry is that whatever causes this noise, which we maybe could filter away in post processing as it is only at a certain frequency, could also cause some other inaccuracies / noise because currently we are trying to use these sensors to meas...

JWoeb.1 · 2021-01-27

Hi,thanks for answering. If set the ODR to a sample rate below the noise signal at 800 Hz it is filtered away by the decimation filter inside the sensor in case of the STEVAL-MKI178V1 board. But because it is ten times stronger on the proprietary bo...

User statistics

User Activity

LSM6DSL Gyro 800Hz Noise

Re: After enabling the sensor hub I2C master bit in MASTER_CONFIG (1Ah) register of STEVAL-MKI182v2(ISM330DLC) I'm not able to read through ISM330DLC register for eg. 0x0f(WHO_AM_I).

Re: After enabling the sensor hub I2C master bit in MASTER_CONFIG (1Ah) register of STEVAL-MKI182v2(ISM330DLC) I'm not able to read through ISM330DLC register for eg. 0x0f(WHO_AM_I).

Re: LSM6DSL Gyro 800Hz Noise

Re: LSM6DSL Gyro 800Hz Noise