About Frakk

Frakk · 2019-12-14

Hi all,I have been pulling my hair out trying different ways to reverse my encoder counting direction.The checkbox "reverse counting direction" in Speed Sensing section does not seem to make any difference. I am using Attolic TrueSTUDIO IDE, and the ...

Frakk · 2020-01-24

Thank you so much Claire,I did read the release notes carefully but I was hoping for an easier path to implement it.I already have a motor driver running fine with a secondary controller in torque mode and I can also do position control if I share th...

Frakk · 2020-01-23

Hi Claire,Can you recommend documentation with regards to the position control feature in 5.4.3, and how to implement the communication protocol?Is there a way to test this feature through the Workbench and Monitor? I'm using the latest WB and I woul...

Frakk · 2019-12-23

I further investigated and were able to make it work. The main issue I had was the fact that WB did not Update the code in main.c whet I clicked "Update". I must click "Generate" for the change to happen. I hope this is not on purpose because simple ...

Frakk · 2019-12-19

Hi Antoine,Thank you very much for your response. I will try this again and change it manually but as I the title says, the checkbox in the WB does not make any difference in the generated code. The reversal/inversion is always disabled.

Frakk · 2018-10-16

I am having the same kind of problem with an even larger motor, 220V, 4.5A, 10Nm running with a 48V motor.

User statistics

User Activity

Encoder "reverse counting direction" checkbox not working in ST MC Workbench 5.4.3. What am I missing?

Re: Recommended setup for small motor position control?

Re: Recommended setup for small motor position control?

Re: Encoder "reverse counting direction" checkbox not working in ST MC Workbench 5.4.3. What am I missing?

Re: Encoder "reverse counting direction" checkbox not working in ST MC Workbench 5.4.3. What am I missing?

Re: MCSDK & Motor Profiler with low RPM BLDC motor