About PD S.1

PD S.1 · 2021-02-15

Hi Experts,I am planning to use stm32l431cb - as it is sufficient controller with 48 pin for my use case. Basically I am trying to find out, how to flash my code into stm32l431cb controller.I referred to a. https://www.st.com/resource/en/datasheet/st...

PD S.1 · 2020-12-26

Hi ST Experts,Recently I have started with experimentation on STM32407 Discovery board. Basically I am trying to implement CAN bus listener for particular ID from the vehicle. For my testing I am hooking on to OBD (where I have OBD unit to read the ...

PD S.1 · 2021-02-16

Thanks a lot guys :folded_hands::folded_hands::folded_hands:. Now I have some idea on how to progress and again some questions :)I am doing my own design - I am not using any dev boardI think with BOOT0 pin (pulled high during reset) - I should be ab...

PD S.1 · 2021-01-15

Hi Aviel,Sorry - yesterday was holiday in India and I did not look into my emails. As I mentioned earlier, there was no change in the code - it was basically issue with my transceiver (not connected properly).Any way please find my .ioc and main file...

PD S.1 · 2020-12-29

Hi KnarfB,Thanks a lot. The code was correct :) but the connection to transceiver was faulty and that was causing this problem. Any way now I am able to see the response triggering the read interrupt when I read some standard values like RPM (from ot...

User statistics

User Activity

How to flash the compiled code to stm32l431cb

Reading from CAN bus (just as plain listener)

Re: How to flash the compiled code to stm32l431cb

Re: Reading from CAN bus (just as plain listener)

Re: Reading from CAN bus (just as plain listener)