About RomanMH

RomanMH · 2018-09-06

Hello!I'm experiencing difficulties using STM32-MAT-TARGET to generate code for STM32 controllers from Simulink models using the provided blocks for USART communication.I'm using this setup:Nucleo-F401REUSART1 and USART6 with interrupt enabledEXTI1 a...

RomanMH · 2018-09-06

I discovered something new:I use this minimal example for testing purposes:This generally works. Though it doesn't work anymore when I enable the USART1 (the other USART I enabled in Cube but do not use here) interrupt.So the issue is having two USAR...

RomanMH · 2018-09-06

I tried it again with low priority for the DMA channels. That didn't make a difference.I checked and verified that the UART interrupt is enabled.I'm generating code with Simulink (slbuild) and compile it with gmake. It's an automated process. I don't...

RomanMH · 2018-09-06

Thank you for the suggestion. I tried it with DMA mode.This time I get no response at all.

RomanMH · 2018-09-06

I have to use Cube configuration and then use the code generation from within Simulink. The process is automatic and I cannot edit the code manually.

User statistics

User Activity

STM32-MAT-TARGET: Simultaneous reception on two different UARTs

Re: STM32-MAT-TARGET: Simultaneous reception on two different UARTs

Re: STM32-MAT-TARGET: Simultaneous reception on two different UARTs

Re: STM32-MAT-TARGET: Simultaneous reception on two different UARTs

Re: STM32-MAT-TARGET: Simultaneous reception on two different UARTs