About HGohe

HGohe · 2018-08-24

Hi All,I am working on the LIS3MDL register on my board. But When I try to measure the Magnetic field Produced by motors, I am getting very high deviation.My settings for the LIS3MDL are as below.0x22 -- 0x00 (also tried with 0x22 -- 0x03)0x21 -- 0x0...

HGohe · 2018-09-13

Hi @Miroslav BATEK ,Thank you for insde, Let me try with the configuration for ctrl_reg4 as you have suggested. I am implementing DRDY setting, (As in project, middle layer and application is already implemented, So going through them on driver leve...

HGohe · 2018-09-12

Hi @Miroslav BATEK ok,Let me try that way,But Also Today I did one interesting thing.I collected the raw samples from sensors, And I converted to FFT.In fft , Though I have selected sampling freq. 300hz in reg. but when I gave sampling freq 250 (in ...

HGohe · 2018-09-11

Ok,So what do suggest is good way to check as I need to collect the raw data.And Here I am collecting is raw samples from the registers.For collecting some 1000 samples , By the DRDY signal approach will take longer time.

HGohe · 2018-09-10

Hi Miroslav,My settings in CTRL_REG1 is = 0x5E,Reading data on 300 hz speed.( In main application it will be user defined, but the readings pasted here is on 300 hz.Right now I am not using DRDY interrupt., And I read data directly from x,y,z registe...

User statistics

User Activity

LIS3MDL Magnetometer data reading Error

Re: LIS3MDL Magnetometer data reading Error

Re: LIS3MDL Magnetometer data reading Error

Re: LIS3MDL Magnetometer data reading Error

Re: LIS3MDL Magnetometer data reading Error