About YIshi.1

YIshi.1 · 2024-01-13

I created a new board using STM32L431CBT6. The initial programming of the board was successful. However, once a program was written, I found that it couldn't be modified again. I suspected it might be related to Boot settings, so I tried changing Boo...

YIshi.1 · 2021-07-29

I usually use STM8L151C8T6 micro-controller.But it's difficult to get it.What does ST Micro think the major/main products on STM8 CPUs families?Should I change the micro-controller from STM8L151C8T6?So, what kind of families should I use?Please tell ...

YIshi.1 · 2024-01-22

There was a delay due to shipping problems in the US, but I received the official ST-Link/V2 today (purchased from the DigiKey site from the ST official site).After connecting, there were no problems at all.I pulled down the Boot0 pin at 10K, didn't ...

YIshi.1 · 2024-01-14

I bought below one.https://www.amazon.co.jp/gp/product/B0BV9QP9D2/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1Standard STMicroelectronics distributors are below(I can access them).DigiKey/RS-COMPONENTSAfter purchasing from them, I'll try again an...

YIshi.1 · 2023-07-19

A few days ago, I made a mistake and left the weight on the return key, and a lot of STM32CubeIDE started up. I forcibly rebooted the PC in the middle, but after that I couldn't access ST-Link at all, so I had no choice but to process it on another P...

YIshi.1 · 2021-07-29

Dear Tesla-san,Thank you for your advice. I know this situation, then I think I'll search other options.

User statistics

User Activity

I cannot connect ST-LINK/V2

products supply

Re: I cannot connect ST-LINK/V2

Re: I cannot connect ST-LINK/V2

Re: Failed to launch child process <gdb.exe>

Re: products supply