About MNazir

MNazir · 2021-10-04

Hi everyone,I am unable to start a Maxon "EC-max 30" BLDC motor (ref 272766) with "NUCLEO-L476RG" development board & "X-NUCLEO-IHM08M1" expansion board using "MotorControl Workbench 5.Y.2" and its corresponding "Motor Pilot 5.Y.2".First of all, the ...

MNazir · 2020-11-26

Objective: I am trying to perform a basic comparison between two values via TS332 comparator. Details: The comparator's inputs are output from Nucleo STM32L432KC DAC. The code for DAC values generation is verified using the internal comparator which ...

MNazir · 2021-10-06

Hi Vijay,The bus voltage in my case is 12V which is the nominal voltage supply of the motor so I cannot decrease it much since it should be at least 10V for the expansion board.Increasing the voltage supply to 24V yields the same results for me. Did ...

MNazir · 2020-11-26

Thank you for the proposal.i actually also tried a simpler setup where I used a voltage supply directly for IN+ & IN- which yielded the same result.I will try pulling up IN+ and keep you informed.

MNazir · 2020-11-26

Thank you for your answer.The wrong/bad connections were the first thing that occurred to me so I soldered another piece of the comparator on another PCB but I have the exact same behavior so I highly doubt that this is the source of the problem.Mayb...

User statistics

User Activity

Cannot start BLDC motor with NUCLEO-L476RG & X-NUCLEO-IHM08M1using MotorControl Workbench 5.Y.2

TS332 comparator not working as expected

Re: Cannot start BLDC motor with NUCLEO-L476RG & X-NUCLEO-IHM08M1using MotorControl Workbench 5.Y.2

Re: TS332 comparator not working as expected

Re: TS332 comparator not working as expected