About Denise SANFILIPPO

Denise SANFILIPPO · 2024-12-09

Summary This article showcases how to develop an end-to-end IoT solution with ST AIoT Craft. In fact, ST AIoT Craft also sets up a full IoT system where the sensor board is connected to a gateway and the gateway communicates with a cloud application...

Denise SANFILIPPO · 2024-12-05

Summary This article showcases how to get started with ST AIoT Craft tool to develop your IoT solution based on advanced edge AI features within ST smart sensors. This new tool has been created to provide an experience to program ST smart sensors wi...

Denise SANFILIPPO · 2024-11-12

Summary This article showcases how you can implement a neural network on LSM6DSO16IS and ISM330IS with ISPU using ST ecosystem based on boards and software tools. 1. Hardware and software prerequisites ST offers two kinds of sensors with ISPU, one f...

Denise SANFILIPPO · 2024-11-07

Summary This article showcases the ISPU capabilities in gesture recognition applications. It focuses on movements performed with a magic wand. ISPU is an ultralow power, computationally efficient, high-performance programmable core that can execute...

Denise SANFILIPPO · 2024-10-23

Dear community members,Here’s your chance to win some prizes from ST until the end of 2024! You can join the challenge by sharing your ISPU neural network implementation. We’ll provide instructions and hints during the ISPU webinar held on October 29...

Denise SANFILIPPO · 2024-12-18

Hi @benx1326, the deadline for this challenge has been extended, so you can still submit your idea in this thread. Go ahead, new ideas are more than welcome!

Denise SANFILIPPO · 2024-12-16

Hi @marti3110 , the I2C is configured at 100 kHz inside the code you shared, not 400 kHz (see below the code in bold). 921600 bits is the baud rate of the UART, it has nothing to do with I2C. static void MX_I2C1_Init(void) { /* USER CODE BE...

Denise SANFILIPPO · 2024-12-12

Hi @marti3110, here are some tips/comments which can help you: - Using FIFO in FIFO mode or continuous mode does not change anything if the data is read and the FIFO does not fill up.- Surely you could use I2C at 400 kHz instead of 100 kHz, in fact a...

Denise SANFILIPPO · 2024-12-10

Hi @marti3110 ,what do you mean with "the data is very skewed and the quaternions are completely wrong"? Can you explain it better?

Denise SANFILIPPO · 2024-12-02

Hi @Hank_Xiao , please post this comment inside the MEMS&Sensors community forum. The content of your post can be useful to other users of that forum and it is out of scope for this challenge. In fact here ST is encouraging the development of applica...

User statistics

User Activity

How to develop an end-to-end IoT solution with ST AIoT Craft

How to get started with ST AIoT Craft to develop your IoT solution

How to implement a neural network on LSM6DSO16IS and ISM330IS with ISPU

How to create a gesture recognition application with ISPU

Challenge: share your ISPU neural network implementation!

Re: Challenge: share your ISPU neural network implementation!

Re: How LSM6DSV16X enables sensor fusion low power (SFLP) algorithm

Re: How LSM6DSV16X enables sensor fusion low power (SFLP) algorithm

Re: How LSM6DSV16X enables sensor fusion low power (SFLP) algorithm

Re: Challenge: share your ISPU neural network implementation!