About Sjosh.2

Sjosh.2 · 2021-01-12

Sjosh.2 · 2021-01-05

Sjosh.2 · 2020-12-07

Sjosh.2 · 2020-12-14

i have enabled the quad mode i.e, quad enable bit but im getting the same problem.

Sjosh.2 · 2020-12-09

im using IS25LP128/064

Sjosh.2 · 2020-12-08

i have checked device ids for 1,4 qspi line, for 1 line im getting the correct device ids, for 4 qspi lines im getting the wrong values and for erase operation for 1 qspi lines im getting 0xFF and when i erased for 4 qspi lines im getting 0xCC instea...

User statistics

User Activity

Hello, im working on STM32F103C8T6 controller, i am doing Low Power Mode ,in that i have to do standby mode, how can i do standby mode with RTC with alarm wakeup or by watchdog or any other wakeup in this controller? suggest the method to do standby mode

im using STM32F103C8T6 controller and im testing ADC for multiple channels (2 channels) but im not getting voltage when im using multiple channels but im getting voltage when im using single channel. why it is not working for multiple channels?

im using stm32l433rbt6 controller in that im working on nor flash using qspi mode i have written some dummy data and im reading that and im getting output as 0xCC when im reading rather than which i gave why im getting 0xCC?

Re: im using stm32l433rbt6 controller in that im working on nor flash using qspi mode i have written some dummy data and im reading that and im getting output as 0xCC when im reading rather than which i gave why im getting 0xCC?

Re: im using stm32l433rbt6 controller in that im working on nor flash using qspi mode i have written some dummy data and im reading that and im getting output as 0xCC when im reading rather than which i gave why im getting 0xCC?

Re: im using stm32l433rbt6 controller in that im working on nor flash using qspi mode i have written some dummy data and im reading that and im getting output as 0xCC when im reading rather than which i gave why im getting 0xCC?