About DKers.1

DKers.1 · 2020-11-05

I use Cube Programmer V2.4 and i am programming the chip using USB DFU mode. Its a simple firmware with a blinking LED to get to know how programming unsing DFU works. I tested the firmware on the NUCLEO L432kc board and there it seems to work fine.T...

DKers.1 · 2020-11-26

Thank you all for your help,For some Reason removing the HSE from the PCB kind of fixed the problem. After removing the HSE and its load Capacitors from all 10 sets of Hardware, the Software seems to function without a hitch on all of them (exept for...

DKers.1 · 2020-11-08

Hi, thanks for the sugestions.I have erased the MCUs User Flash and not configured any Clocks or PLL, just uploaded the original Firmware with Mbed as well as HAL firmware. (I have not tried blank C code yet). Still not working. Could not get any Per...

DKers.1 · 2020-11-05

Thanks for your anwsers!I tried the following:Cube Programmer using USB DFU mode and selection "Run after Programming" -> Cube Programmer sucessfuly programs the chip then initiates start sucessfully but nothing happens.Then i tried to see if BOOT0 i...

User statistics

User Activity

Hi, I reacently desgined my first custom STM32 hardware. I am using an STM32L432KCUx controller and the firmware i programmed it with does not seem to be executed.

Re: Hi, I reacently desgined my first custom STM32 hardware. I am using an STM32L432KCUx controller and the firmware i programmed it with does not seem to be executed.

Re: Hi, I reacently desgined my first custom STM32 hardware. I am using an STM32L432KCUx controller and the firmware i programmed it with does not seem to be executed.

Re: Hi, I reacently desgined my first custom STM32 hardware. I am using an STM32L432KCUx controller and the firmware i programmed it with does not seem to be executed.