About YAdan

YAdan · 2020-03-27

I have built a custom board using STM32F746BET6. I have MT25QL512ABB8ESF-0SIT flash connected to the STM32F746BET6 (same pins as the discovery board) . When I upload my code ST-Link does not write into the external flash. Uploading the hex file goes ...

YAdan · 2020-05-15

As far I understand the I2C is needed if you are using the touch functionality. For display only you don't need I2C.

YAdan · 2020-04-20

Hi Matin,Thanks for the advice. Eventually I learned how to use the debugger.The Hardware integration on STM32F769 with TouchGFX – Webinar code helped eventually finding the problem. I have found the solution on their LED part. I am not very familiar...

YAdan · 2020-04-05

Hello everyone,It doesnt seem to be a popluar subject for the tutors although very important.I am doing something similar but still learning how to do it. So far the closest example I found is the following https://www.youtube.com/watch?v=jQO7zhX0e0Q...

YAdan · 2020-03-28

Hi Andreas,Thank you for your answer and yes you are right the capacity is quadruple not double. Honestly this shows how clunky all this ST business is and everyone is saying that. However, the STM32F7 series are wonderful controllers and I can't be ...

YAdan · 2020-03-11

Hello Sahil Ahmad,I hope you know this post concerns only custom boards using RK043FN66HS-CTG LCD.Find below the two connectors pinout for my LCD side.On the MCU side I am using a diffrent package than the discovery board but should be the same.The N...

User statistics

User Activity

ST-Link not configuring QSPI flsah for STM32F746

Re: Display RK043FN66HS-CTG from Rocktech

Re: External events as triggers

Re: External events as triggers

Re: ST-Link not configuring QSPI flsah for STM32F746

Re: Display RK043FN66HS-CTG from Rocktech