About jstor.1the lost one

jstor.1the lost one · 2020-10-28

I have the arduino 1.8.12 IDE, and the latest 1.9.0 stm cores installed, my question is why dont the st link show up in the upload methods ? it only shows STM32cube programer type also HID Bootloader 2.2, the st link shows up in the device manager a...

jstor.1the lost one · 2020-10-26

can anybody tell me how to get in the Black Pill fourum ?

jstor.1the lost one · 2020-10-26

I have a stm32f401 black pill, question is can you program it with the st linkv2 on an arduino IDE ? and if yes is there any tutorials on this subject ? I have already been able to program the blue pill with no problems using the uploaded bootloader

jstor.1the lost one · 2020-10-18

I dont know much about all this and I want to learn how to change functions in the GPIO registers. do You use the Cube IDE ? and are there any good tutorials on how to change pin functions ?

jstor.1the lost one · 2020-10-18

jstor.1the lost one · 2020-10-28

***Moderator's Note: content removed for violating the Community Ground Rules of Participation***

jstor.1the lost one · 2020-10-19

Thank you Amel, this was very helpful. the chip I have is green in color but is labeled as black pill, stm32f401ccu6. my main question about this chip is it the same as the version 2 as far as alternate functions ? and are gpio pins the same as far a...

jstor.1the lost one · 2020-10-17

GPIO pins, can you assign them different tasks or identity and is there doc i can go to to learn this ?

User statistics

User Activity

STM32f401 and arduino IDE upload question

I think I am in the wrong place

How to program stm32f401 black pill with Arduino IDE?

How to change pin functions?

I have a black pill, but board is green in color, chip says stm32f401ccu6, 44pin. where can i get a pinout diagram for this board, ? only blackpill boards pinouts that I can see are the newer 40 pin boards

Re: STM32f401 and arduino IDE upload question

Re: How to change pin functions?

Re: I am completely new here, question-how is the best way to get started using the cube ide and my new stm32f401 series chips as far as manipulating the ports ?