About SZamm.1

SZamm.1 · 2021-01-03

I am working with the NUCLEO-F401RE board with the ST link connection and I have connected the SWD cables to the STEVAL GPT001V1 energy harvesting watch dev kit. I am following the user manual and it says I have to use this .bin file but I cannot fi...

SZamm.1 · 2020-11-16

SZamm.1 · 2021-01-07

@Eleon BORLINI Thanks! I just send you a private message

SZamm.1 · 2021-01-04

Thank you @Eleon BORLINI ,If it is possible, would you be able to post here or send me the STSW-GPT001V1.bin file? I was hoping to test the firmware due to it's ability to enter a low consumption mode (sleep mode) in case the app is closed (BLE netw...

SZamm.1 · 2020-11-17

Thank you Eleon. Do you know if the STWINKT1 can support a GPS addon board as well as the stMOD+ LTE pack at the same time?I was looking into the different MCUs that are in the sensorTile and the STWINKT1. Do you know what the difference is between t...

User statistics

User Activity

Where do I find the STSW-GPT001V1.bin file?

How would I go about adding GPS and Cellular connectivity to the SensorTile? I was looking into using the Cellular LTE-M and NB-IoT connectivity expansion board with STM32L496AG MCU and the Teseo-LIV3F GPS module.

Re: Where do I find the STSW-GPT001V1.bin file?

Re: Where do I find the STSW-GPT001V1.bin file?

Re: How would I go about adding GPS and Cellular connectivity to the SensorTile? I was looking into using the Cellular LTE-M and NB-IoT connectivity expansion board with STM32L496AG MCU and the Teseo-LIV3F GPS module.