About Rookie38

Rookie38 · 2024-11-21

Hello ST Community, for the STM32H5, STM32U5 and STM32U0 series, it is already possible to use USBX without ThreadX using CubeMX. After my research, I have a few questions:Why was this limited to these STM32 series only? Are there plans to support th...

Rookie38 · 2022-11-16

Hello ST Community,currently I am thinking about how to ensure that different developers working on the same project are able to keep exact results. Building, linking, debugging and flashing process should be reproducible and identical for my purpose...

Rookie38 · 2022-10-19

Hello ST Community,In my application I want to pull up a Battery Latch Pin for a short time in VBAT mode using the integrated RTC Alarm Events.Based on the datasheet of the STM32F722xx STM32F723xx it is described that:When the microcontroller is supp...

Rookie38 · 2022-10-12

Dear ST Microelectronics Team,I want to connect a STM32F723IE with I2C as master, which is powered with 3.0V, to a bus with one slave with 3.0V and to another slave with 3.8V. From the datasheet I can see that the GPIOs are 5V compliant, but can the ...

Rookie38 · 2022-10-06

Hello Community,when I enable the "Shared" option when connecting with STM32_Programmer_CLI.exe software, I notice that the serial number option ("sn=<>") is completely ignored. Is this a bug? The result is that wrong MCUs are flashed during a flash ...

Rookie38 · 2022-11-17

Thanks for the input. I will try the way with the separate repositories to manage the toolchain and remaining development tools. In the CubeIDE settings I have seen that it can also be referred to a separate toolchain, but tools such as STM32CubeProg...

Rookie38 · 2022-10-19

Thank you very much for the hint. I should have looked directly at the reference manual instead of the processor data sheet. As soon as I have read more about the functionalities of the RTC, I will start the implementation.

Rookie38 · 2022-10-12

Now I have also found out when exactly this scenario occurs. In another script, I connect to the ST link of the STM32F7 to process the SWD messages. The command is as follows: This connection is not shared and causes another STM32Cube instance to not...

Rookie38 · 2022-10-12

I suspect I have discovered the problem:The ST-Link of the STM32F7 is not recognized and when this scenario occurs, for whatever reason the second ST-Link (STM32F4) is flashed although the serial number does not match: Line 23-27 Device is missing!po...

Rookie38 · 2022-10-12

Hello Aziz,I apologize for the late feedback. When rereading my post, I expressed myself a little too vaguely. My setup looks like this: When I run with the following command to flash the STM32F7 Disc, the STM32F4 Disc is flashed:powershell "& '..\fw...

User statistics

User Activity

Standalone implementation of USBX ,MTP Support, STM32 USB Middleware

Control and management of toolchain and other tools to create reproducible firmware

Is it possible to trigger a GPIO pin by an RTC alarm in VBAT mode only?

Using STM32F723 I2C with multiple slaves at different voltages

STM32_Programmer_CLI.exe ignores serial number in shared mode

Re: Control and management of toolchain and other tools to create reproducible firmware

Re: Is it possible to trigger a GPIO pin by an RTC alarm in VBAT mode only?

Re: STM32_Programmer_CLI.exe ignores serial number in shared mode

Re: STM32_Programmer_CLI.exe ignores serial number in shared mode

Re: STM32_Programmer_CLI.exe ignores serial number in shared mode