About Hamid1

Hamid1 · 2021-02-19

I mean, I setup TIM1 CH1 as output PWM, One pulse mode, but I need to trigger it by my codesfor example which register should be set to high or low to generate a pulse on TIM1 CH1

Hamid1 · 2021-02-19

Dear JanIt is working now,.. thank you

Hamid1 · 2021-02-19

Thanks, I will try it and hope to reach it:grinning_face:

Hamid1 · 2021-02-19

Only Switching is suitable, linear regulators is based on resistor and will be hot for current more than 1 ampere .. but switching regulator is frequency based and never will be hot by good config of Duty cycle and frequency !

Hamid1 · 2021-02-19

is it right ?Trigger source : ITR0

Hamid1 · 2021-02-19

Thanks Waclawek.. so that, which is trigger source ? which trigger source I should select in config ?

User statistics

User Activity

Hi I need to generate a one pulse mode, but I need to trigger PWM inside software by writing code not by trigger a pin in CPU.. How could I do it ? which register should be 1 ?

Re: Hi I need to generate a one pulse mode, but I need to trigger PWM inside software by writing code not by trigger a pin in CPU.. How could I do it ? which register should be 1 ?

Re: Hi I need to generate a one pulse mode, but I need to trigger PWM inside software by writing code not by trigger a pin in CPU.. How could I do it ? which register should be 1 ?

Re: Regulator Selection with Ultra Low Quscient current

Re: Hi I need to generate a one pulse mode, but I need to trigger PWM inside software by writing code not by trigger a pin in CPU.. How could I do it ? which register should be 1 ?

Re: Hi I need to generate a one pulse mode, but I need to trigger PWM inside software by writing code not by trigger a pin in CPU.. How could I do it ? which register should be 1 ?