About SChab.1

SChab.1 · 2020-09-29

My LIS3DH is embedded on a PCB with gravity on Zh (upside down).It is configured with:ODR 10Hz, Z axis enabledNo filterFS @2HzIA1 on INT1Interrupt active HIGHAOI and 6D pos (for position detection)INT1 threshold set to 0x39 (around 0.916g)This config...

SChab.1 · 2021-09-16

Hi @Eleon BORLINI ,Sorry not to have work on the subject earlier, but had a lot of work to do lately...I tried to change the LIS3DH programing with the following:simple interrupt with ZLIE activatedthreshold set to 0x35The situation is:good interrup...

SChab.1 · 2020-10-02

Thanks for the suggestion @Eleon BORLINI , I will try this out and keep you in touch!

SChab.1 · 2020-09-29

Hi @Eleon BORLINI ,Thanks for the reply: I have already read Datasheet and AN3308 lots of time to check if I did not miss something in them..You understood what I do (and have explained).What I do want to do is the contrary, but I did not find any w...

SChab.1 · 2020-09-29

To add some details, in my current use of the accelerometer, any shock is triggered, what I would like to avoid using the INT1_DURATION register value (low pass filter).If trying to use other axis (Zl, X[h/l], Y[h/l]) and an adapted threshold, interr...

User statistics

User Activity

LIS3DH - Cannot have position detection running properly

Re: LIS3DH - Cannot have position detection running properly

Re: LIS3DH - Cannot have position detection running properly

Re: LIS3DH - Cannot have position detection running properly

Re: LIS3DH - Cannot have position detection running properly