About lukaskostorz9

lukaskostorz9 · 2015-07-30

Posted on July 30, 2015 at 14:17Hello I generated code using CubeMX in order to measure a pulse (20Âµs - 100ms). TIM2 is what I am using for that. In the HAL_TIM_IC_CaptureCallback I am checking the value in the CCR1 register. I am expecting that in...

lukaskostorz9 · 2015-06-08

Posted on June 08, 2015 at 09:59Problem solved.. I realised, that the slave does not react to the CSn properly. After some investigation I looked again at the slave code and found that the slaves' CS input was not configured. After setting it to inp...

lukaskostorz9 · 2015-06-07

Posted on June 08, 2015 at 07:36Unfortunetaly it is not possible to put a bigger µC on the prototype board. I had a look on the hardware. I also was looking for a spike that might cause the ''missing'' clock but found no sort of that. Signals were m...

lukaskostorz9 · 2015-06-01

Posted on June 01, 2015 at 09:46Hi, I do not see any reason for posting the code unless you provide a reasonable idea why this might help. Even so I do not see the cause in the code. Please read the preceeding post. Running it on a 31 Eval board, ...

lukaskostorz9 · 2015-05-29

Posted on May 29, 2015 at 11:35 Hi, what we did in a first set-up was to connect two STM32051 as master and slave (both on eval boards) to reproduce the problem. As a result we got correct behaviour from master as well as from the slave (Interr...

User statistics

User Activity

STM32F0 input capture ( CCR1 stays 0)

Re: SPI controller on Slave generate RXNE interrupt before last bit was received

Re: SPI controller on Slave generate RXNE interrupt before last bit was received

Re: SPI controller on Slave generate RXNE interrupt before last bit was received

Re: SPI controller on Slave generate RXNE interrupt before last bit was received