About PFuen.1

PFuen.1 · 2020-09-16

Hi, recently I got a X-NUCLEO-BNRG2A1 and I am trying to use it with NUCLEO-G070RB without success. I have created a project with STM32CubeMx assistance using SampleApp of X-CUBE-BLE2, mapping the pins of the expansion board to my nucleo board as fol...

PFuen.1 · 2022-12-22

@satyam9896 Hmm, have you already flashed the BlueNRG-M2 with the firmware DTM_SPI.hex? The chipset needs to have that firmware to work as a network co-processor, otherwise it is in host mode.

PFuen.1 · 2022-12-21

@satyam9896 Hmm no, remove "hci_tl_lowlevel_isr" from there. When using the HAL it should be done with the function HAL_EXTI_RegisterCallback. You have to only check that you have this in "stm32xxx_it.c":void EXTI0_IRQHandler(void) { HAL_EXTI_IRQ...

PFuen.1 · 2022-12-20

@satyam9896 hi, yes I did, however I don't remember exactly what it was. - You should check if "hci_tl_lowlevel_isr" is called in the external pin interrupt.- SPI MUST have this configuration: ClockPhase: LL_SPI_PHASE_2EDGE ClockPolarity: LL_SPI_PO...

PFuen.1 · 2020-09-23

Thank you too, I had given up, but when I saw that there was someone else with this problem, I tried again. I manage to get it work with UserBoard too, STCubeMx does not put the interrupt handler, so that's why it got stuck there, I just add this to ...

PFuen.1 · 2020-09-23

I manage to make it work! However I am not sure why using the STM32CubeMx does not work. The problem appears to be the SPI frequency (it must be 1MHz). It works with a HAL that I developed, but it does not work with ST HAL, I don't know if I am doing...

User statistics

User Activity

X-NUCLEO-BNRG2A1 stuck on reset using X-CUBE-BLE2

Re: X-NUCLEO-BNRG2A1 stuck on reset using X-CUBE-BLE2

Re: X-NUCLEO-BNRG2A1 stuck on reset using X-CUBE-BLE2

Re: X-NUCLEO-BNRG2A1 stuck on reset using X-CUBE-BLE2

Re: X-NUCLEO-BNRG2A1 stuck on reset using X-CUBE-BLE2

Re: X-NUCLEO-BNRG2A1 stuck on reset using X-CUBE-BLE2