About stst9185

stst9185 · 2023-03-30

stst9185 · 2020-10-26

On a serial product after a firmware update, there are some sporadic cases, where we get a hang up situation. It would be very helpful to know where exactly the program is stuck. According to ES0346 Rev. 6 chapter 2.8 it is possible to access progra...

stst9185 · 2019-08-28

If I generate a slider in a screen in the Designer 4.10.0, I get the additional interaction selections like "Slider value changed" etc. If I generate a scrollable container or a scroll wheel, I get no such possibility to react to changes. How can I a...

stst9185 · 2010-09-20

Posted on September 20, 2010 at 09:29 SDIO-interfacebis an issue for me too

stst9185 · 2023-04-06

Great, now I can select the right module! It is a bit confusint, that there is a Unico software and a Unico-GUI software and they have different scopes of supported products.Thanks!

stst9185 · 2020-10-29

That Flash is not blank is sure, as after a reset the program operates normally. Stack seems to have no problem, as the area is pre-filled with a pattern and so an overflow can be excluded. But what exactly do you mean with "I´d use an EXTI Interrupt...

stst9185 · 2020-10-29

Thanks for the tip, I didn´t recognize this first. I still wonder why there seems to be a reset although the mode setting is HOTPLUG.

stst9185 · 2020-10-29

Yes of course I have tried this as well, but my problem is, that the hang-up is not frequently enough to have a realistic chance to get it in the debugger, but it is too often for accepting it for our customers.

stst9185 · 2020-10-28

I will do these things, but as a first step, I would like to find out, where exactly the code hangs. So I tried to get the program counter with:STM32_Programmer_CLI.exe -c port=SWD mode=HOTPLUG -coreReg PCthis gives the register values, and other val...

User statistics

User Activity

I have bpought a STEVAL-MKI109V3 + STEVAL-MKI105V1, but in UNICO Lite Rev. 3.0.0.0. I cannot find a selection for this kit, probably firmware of the board has to be updated. Cube Programmer is already installed, but where can I find the firmware image?

Is there a possibility to read program counter via ST-Link or J-Link without causing a reset on STM32F103 devices with RDP active?

How do I get Interactions for scroll wheels etc. ?

SDIO-interfacebis an issue for me too

Re: I have bpought a STEVAL-MKI109V3 + STEVAL-MKI105V1, but in UNICO Lite Rev. 3.0.0.0. I cannot find a selection for this kit, probably firmware of the board has to be updated. Cube Programmer is already installed, but where can I find the firmware image?

Re: Is there a possibility to read program counter via ST-Link or J-Link without causing a reset on STM32F103 devices with RDP active?

Re: Is there a possibility to read program counter via ST-Link or J-Link without causing a reset on STM32F103 devices with RDP active?

Re: Is there a possibility to read program counter via ST-Link or J-Link without causing a reset on STM32F103 devices with RDP active?

Re: Is there a possibility to read program counter via ST-Link or J-Link without causing a reset on STM32F103 devices with RDP active?