Posted on February 11, 2016 at 17:04I use STM32f103RCT6 to blinking led in pin A8 with 1 second delay, and i try to use logic analyzer to see whether it's right. However, when i setup in ''Current Logic Analyzer Signal'', i write PA.8 in it and it s...

Posted on January 11, 2016 at 16:33i am going to connect stm32f103rct6 to ZM serial camera 320x240 pixel, 30fps. i see this camera probably easier than ov7670. i have used stm32f4 with ov7670 but it really hard and difficult, so i want use stm32f103...

Posted on January 10, 2016 at 10:56I use stm32f4 discovery connect with camera OV767 to capture picture and send it to uart4. But when i use DCMI_Cmd(ENABLE); First, i just want send 'A' but i can't. What happening with DCMI or when i use DCMI, i mu...

Posted on January 07, 2016 at 17:54Hello,I use STM32F4 discovery board connect to cmos digital camera OV7670, I know STM32F4 have DCMI which have capture image from camera and i have sent success image from camera to TFT 2.8 inch(DCMI -> FSMC though...

Posted on November 11, 2015 at 17:02Hi everone, i have some problem with stm32f4 discovery. i use  STLink-utility , when i  try to connect to target, it always show ''Can not read memory. Disable read out protection and retry''. i was search in inte...