About Chris19

Chris19 · 2021-07-26

Chris19 · 2021-07-25

Chris19 · 2021-05-17

We are planning to make a custom debugger using STM32WB55RG. For communication with openOCD, we have customized the DAPLink firmware. Is it possible to use STM32Cube IDE with OpenOCD as debugger for our custom board, or do we require a custom tool?

Chris19 · 2020-09-13

Hi,Can ST-Link be used to program both M0 and M4 cores? Also if the controller in STLink is replaced with STM32WB55RG can the driver for STLink be customized or does it require a new driver development? Is the driver open source? If yes, on what form...

Chris19 · 2020-08-09

Chris19 · 2020-09-25

Hi,https://www.st.com/en/development-tools/stsw-link007.htmlFor firmware update this can be used right? Will the firmware be accessible to users? If not, will there be an option in the tool to choose the controller and give the configuration of pins?...

Chris19 · 2020-09-15

Hi,In ST-Link, can we get the firmware used in STM32F103CBT6?

User statistics

User Activity

In which structure is end points defined in STM32 Cube?

STM32WB55RG USB Base Address from STM32Cube is (0x40005C00UL) and that from the reference manual is 0x40006800. Which one is right?

For debugging using OpenOCD in CubeIDE, can a custom board be used?

STLink Dual Core programming

I am using STM32WB55RG board and its USB stack. Please give a suggestion on which driver to be used in the PC side.

Re: STLink Dual Core programming

Re: STLink Dual Core programming