In an Project, I'm using Jump to boot Function to jump to STM32 Factory Bootloader, so that i can able to load new firmware from USB via “STM32 Cube Programmer�? CLI Method (from our own system application).It is working fine when Read Out Protection...

Posted on September 22, 2014 at 11:45I want to interface LCD 800 x 600 x RGB 24 bit Display. for that i used SDRAM, NAND Flash, and other needed like touch Controller, SDCard, USB 2.0 etc. While designing in Cube i found that NAND and SDRAM shares t...