I have question about value of the TIM2_CH1 and TIM2_CH2 if they are not selected by any pin in AFR registers. Is there "default connection" or they are left floating or they are grounded?I need to know this as I cannot use these two inputs on any pi...

Posted on March 24, 2018 at 10:29I met an interesting problem. When I tried to configure this IO with SD widebus config (4bit) with hal libraries I always failed with initialization because pin 1 of SD card is on logic 0.The solution was firstly let...

Posted on March 01, 2018 at 19:03Hello,recently I am trying to make some device communicating via USB virtual com port. Firstly, device has sometimes problem to enumerate itself:[1922765.320415] usb 1-1.2: new full-speed USB device number 34 using e...

Posted on August 25, 2014 at 19:58I read the reference manual for circuit mentioned but I cannot find any flag in register for USART that will show there is some transmission/reception active. Is there someone who solved similar problem? I need this...