Hello,I am using +/-40V to power TDA7293 and have no issues with its application. I want to power an audio processor from the +40 supply rail. The audio processor needs 3.3V.Kindly suggest a scheme to achieve this.I am concerned about the power dissi...

The datasheet of the TDA7294 audio amplifier suggests a bridge topology through Fig. 25 on page 13 of the datasheet. The design seems elegant as it does not use any external op-amps to generate complimentary signals.However I have a few questions/ co...

Posted on August 28, 2017 at 06:46For a new design, I need an AES/ EBU receiver IC that can accept balanced inputs. The STA120D seems fit. However I cannot find the product page on the ST website even though the IC is available on Mouser and Digikey...

Posted on July 27, 2017 at 13:14Hello,Datasheet recommends connecting both MUTE and STBY pins on TDA7293 using R-C for delay to avoid pop noise.I would like to know if I can connect MUTE pin using R-C, as recommended, and connect STBY pin directly t...

Posted on June 02, 2016 at 07:54Dear Support Team, I am using the TDA7293 as per datasheet recommendations. I am also using the MUTE and STBY pins but not the CLIP-DET pin. Everything is working without any issues. My question is: 1. Can I connect ...